Register or Log In now Trying to figure out which coolant to use in my 2018 A4 for topping off.
G13 coolant audizine how to#
Note: Cooling system drain and fill due to coolant mixing or incorrect coolant is not covered by warranty. 552946 Location Somewhere My Photo Gallery: 0 Coolant Type: G13 or G12Evo Guest-only advertisement. Is your Audi or VW coolant level low Did the coolant warning light start flashing We show you how to confirm the coolant level and demonstrate the steps of. Tip: If a vehicle is found to have the incorrect coolant, the cooling system should be drained and then filled with the correct coolant. If not, can som eone send me a link to a g13 coolant PEAK is from Autozone Zerex is from O'Reilly Thank you See more Reply Save Like 1 - 17 of 17 Posts 0 05SILVERSTONEGTI1. I was just wondering if these coolants can be used in my car (2005 Jetta gli). (Example: If the car was factory filled with G12++, the coolant allowed is G12++ or G13.) 6 So they have pink and violet coolant which is the same as g12 and g13 I’m pretty sure. The table is read by identifying the factory filled coolant at the top and comparing it to the available service coolants to the left. When the coolant is changed due to a cooling system issue, the cooling system should be drained and filled. Note: G12+, G12++ and G13 coolants are lifetime coolants when used exclusively in the coolant system (not mixed with other coolants).Ĭoolants can be mixed, as described in the chart, but it is always a best practice to change the coolant due to reduced corrosion protection when coolants are mixed.Īdditionally, coolants can be mixed, as described in the chart, when adding/topping off fluid levels. The table identifies which coolant can be added to the factory coolant.
Note: The photo above is for color identification only. Place bucket under the lower radiator hose at the core. Jack front end of car up enough to fit a bucket under the car, on the left side of the radiator core. The photo below shows the color of each type of engine coolant. So here goes: This is the easiest and less messy way to do a complete coolant system flush (with heater core). Identify which coolant the vehicle was filled with from the factory. G13 coolant is introduced on all engines. Coolants G11, G12, G12+ and G12++ have been replaced by an improved version.
0 kommentar(er)
